For staining, primers are also required and then use gels stains with two coats of clear polyurethane. If finishing is desired, both primers and paints labeled “For Plastics” must be used.
PRE PAINNT WIPE RAGES FREE
RSL Injection Molded Maintenance Free frames do not require finishing and retain their original color if unfinished. Injected Molded Frames Commodity R-Frames (White)
PRE PAINNT WIPE RAGES INSTALL
Lower door cut-out onto the frame on the table so that it presses down into the silicone place inside frame into cut-out and snap frame halves together install provided zinc coated screws into predrilled holes loosely tighten with maximum 8-10 inch/lbs of torque and do not over tighten snap (2) short caps on inside frame install (2) longer caps by bowing them in the middle to complete assembly. Remove tabs from glass place frame with glass in it on a clean flat assembly table using tube supplied by RSL neatly apply 3/16″ bead of sealant around the perimeter of the frame. When painting or staining in high heat or dark colors use AquaSurTech/Sherwin-Williams’ D100 Heat Reflective Paint.Īlways install frames with screws to the inside of home. If finishing is desired, simply use latex paint, paint labeled “For Plastics” or gel stains followed by two topcoats of clear polyurethane. Vinyl frames do not require finishing and will retain their original color if unfinished. When painting or staining in high heat or dark colors use AquaSurTech/Sherwin-Williams D100 Heat Reflective Paint.ĭecorative & Commodity Vinyl Frames (White & Tan) RSL Maintenance Freee Huricane Impact frames do not require finishing and will retain their original color if unfinished. Lower door cut-out onto the frame on the table so that it presses down into the silicone place inside frame into cut-out and snap frame halves together install provided zinc coated screws into predrilled holes loosely tighten with maximum 8-10 inch/lbs of torque and do not over tighten snap (2) short caps on inside frame install (2) longer caps by bowing them in the middle to complete assembly. Hurricane Impact Vinyl Frames Installation and Finishing InstructionsĪlways install frames with screws to the inside of home. Any area where the water beads up or pulls back will require more preparation attention before application.
If the water wets out, not beading up or pulling back as it is spread, the polyurethane acrylic water based coating will wet out similarly, helping to produce desirable results of a smooth film formation and adhesion of the coating to the substrate. A water test will serve as an indication as to whether or not the door has been sufficiently prepared and ready for application of a polyurethane acrylic water based coating. It is imperative that the door is completely free of all dirt and dust before application. Glossy areas indicate that sufficient sanding was not done and is required further to gain adhesion.
This will work to ensure that the coating wets out thoroughly in application, resulting in a smooth film with adhesion to the substrate.
0 kommentar(er)
