To enable the MIDI CC send options for the Control 2 Expression Pedal andthe CONTROL Footswitch, follow these steps: The Expression Pedal canact as a continuous control device, and the CONTROL Footswitch can act asa parameter toggle switch. In addition to controlling GSP processor parameters, you can configure theControl 2’s Expression Pedal and the CONTROL Footswitch to send MIDICC (continuous controller) messages on the GSP’s MIDI channel to MIDIdevices connected to your GSP’s MIDI Thru port. You might only be able to set control button 10 and the expression pedal to control the Kemper, as it seems like the other buttons a fixed already. Press one of the footswitches numbered 6-10.The footswitch’s LEDturns on to indicate the effect is active, or turns off to indicate the effectis bypassed.
#Digitech control 2 how to
Make sure the Control 2 is in 5 Patch Mode (see page 5 for instructionson how to switch modes).To turn effects on or off using Footswitches 6-10, follow these steps: "When you load a preset, some effects may already be on.Those effects willhave a lit LED next to their footswitch(es).
#Digitech control 2 manual
It does not matter if I toggle the status of the effects in the KPA rig beforehand.ĭoes anyone have similar experiences or better, a solution (other than "but a Kemper Remote", the Control 2 was VERY expensive as well).Įdit after reading the manual for your controller. Since the other cc's are working, I am guessing that the Control2 is sending the correct cc's. The issue is that when cc's 24 or 29 get send the Kemper reacts, but does it inverse, so on my Control2 the light is off when the effect on the Kemper is engaged and the light is on when the effect on the Kemper is disengaged. I have programmed switch 6 to send cc 17, works fine, switch 7 (chorus) to send cc 24, issue. But, out of the 5 switches (6-10), three work and two do something weird, depending on the effect called on the Kemper. Volume pedal works, tempo tap works, tuner doesn't, but heel down works as well, no so biggy. There is a volume pedal, there is a tuner button, a tempo tap button. On the C2 there are switches 6 until 10 which control Dist, Chorus, Delay, Reverb, Control. I have setup a lot of stuff on the GSP+Control2 which work fine with the Kemper, except one thing.
I love the effects in the GSP and the amps in the Kemper and the C2 floor controller is really awesome, so I would prefer to use that to control the GSP and the Kemper. I already owned a GSP1101 and C2 before getting the Kemper. I have a weird problem with the midi stuff.
0 kommentar(er)
